UltimaSerial
Windaq Add-ons
UltimaWaterfall
XChart
FFT1024
Lessons
|
|
Common Features for the following devices
:
1) Comes with WinDaq data acquisition software and WinDaq Waveform Browser
2) All these devices are supported by UltimaSerial!
RS232 vs USB:
USB is the trend, but RS232 is much reliable in harsh/noisy
environment
.
Data logger |
Connection |
Pros |
Cons |
DI-194
for Simple project and Student
|
RS232 |
1) Never seen a better
value!
2) Four analog channels and three digital channels
3) Powered by the COM port
4) 10-bit resolution, or 20mV minimum voltage change (step) if you use the default input
range (-/+10V)
|
Can't interface with most sensors directly, thus you may need to build your amplifier
circuit for the sensor.
|
DI-154RS great
for
Voltage measurement
|
RS232 |
1) Higher resolution (12 bit), a great data acquisition device!
2) Four analog channels and three digital channels
3) Powered by the COM port |
Can't interface with most sensors directly, thus you may need to build
your amplifier circuit for the sensor.
|
DI-195B
for
industry
users
|
RS232
|
1) Use industry standard 5B
module to interface directly to various sensors, great for industry users!
2) Two analog channels and one digital channel
3) Higher resolution (12 bit)
4) It comes with a power supply, so you can supply excitation voltage to the sensor
|
You need to have an access to an AC power outlet |
DI-148 |
USB |
USB-based. Higher speed, digital and analog outputs Powered by USB port
|
|
DI-158 |
USB |
USB-based. Higher resolution and gain
control |
|
DI-710 for
serious
users
|
USB |
USB-based. 14-bit resolution with gain control This is also a true stand-alone data logger
. You can use DI-710 scheduler
to specify stand-alone recording sessions
for this product |
|
DI-715 for
industry
users
|
USB |
USB-based. Signal conditioning front end This is also a true stand-alone data logger You can use DI-710 scheduler
to specify stand-alone recording sessions
for this product |
|
DI-718 for
industry
users
|
USB |
USB-based. Signal conditioning front end This is also a true stand-alone data logger You can use DI-710 scheduler
to specify stand-alone recording sessions
for this product |
|
What is a stand-alone data logger?:
A stand-alone data logger is a device that logs the data to its internal
memory, such as SD memory card. To set up a stand-alone data logger, a PC is needed to connected
to the data logger. Once the configuration is done, the data logger can be disconnected
from the PC and ready to deploy.
Because Ultimaserial is a PC-based driver, it
doesn't support features available only to stand-alone data loggers, but
you can certainly use DI-710 scheduler to specify stand-alone
recording sessions for this product!
Last update: 02/29/12
Copyright: 2000-2005
www.UltimaSerial.com
|